How-To: Case-Insensitive Searches
Last Updated: 2021-07-04
By default, repository queries in LogScale are case-sensitive. However, when querying a repository, some log lines may be overlooked due to unexpected case of the text. There is a way to resolve this situation.
Work-Around
When searching on a particular term, to make the search
case-insensitive, you can wrap the text with regex delimiters (e.g.,
forward-slashes) and append that with the case insensitivity modifier
(i.e., the letter i
). For
example, to search for events containing the word, Error, you could
enter this in the query box:
/ErroR/i
Notice that the text here includes atypical use of capital letters. Without the insensitivity flag, it would almost certainly return no results. But with it, it will return entries containing no capital letters, all capital letters, or only some.

Figure 307. Case Insensitive Searches
This work-around resolves the problem for a single query; you'll have to use this method for each query for which you want case-insensitive queries. That may be bothersome if you do this often.
It is possible to set the default for searching repositories to
case-insensitive. To do this, first do a search as shown in the
example above, perhaps with the word Text like so:
/Text/i
. Don't worry if it
yields any results.
When ready, click on Save as... near the top right corner of the User Interface. You'll be asked to give the query a name. Do so and then click the Save button.

Figure 308. Setting Default Query
Now go to the Settings tab, to the Basic Information section — it's the opening screen for Settings. At the bottom of that panel, see where it says Default Query, like in Figure 2 here. Click on the pull-down menu there and select the query you just saved, to make it the default one.
After doing this, whenever you open the Search tab, you'll see that query, which will be set for case-insensitive. Then just double-click on the text contained within it and type what you actually want for search text.
To set a particular query to case-sensitive, just remove the case
insensitivity modifier (i.e., the letter
i
) from the end. To set the
default back to case-sensitive, go back to Settings and select another
query or no query (i.e., the blank choice).